User Manual

48
Enter Setup
1662 L/1664 Barcode Scanner User Guide
1.14 PICKLIST MODE (1664 ONLY)
Picklist mode enables the decoder to decode only the barcodes aligned under the center
of the laser aiming pattern.
Enable
*Disable
1.15 PAGER BEEP DURATION
Paging function is only activated when 1662 L/1664 is in Power-Saving mode. 1662
L/1664 can be woken up via receiving any Bluetooth
®
status command by pressing a key
on the host keyboard. The buzzer will continuously sound two short high tone beeps until
the power key is pressed on the scanner or the timeout is reached, and the scanner
re-enters power saving mode.
By default, the pager beep duration is 5 seconds. Specify a value, ranging from 0 to 15.
(0~15 sec.; 0= Disable)
 Bluetooth
®
HID profile: Press any one of the following keys “Scroll Lock”, “Number
Lock” or “Caps Lock” on the host computer to trigger the waking up of 1662 L/1664.
 Bluetooth
®
SPP Profile: Any command sent using Bluetooth
®
SPP will trigger the
waking up of 1662 L/1664.
Pager Beep Duration
0
~15 sec.
(*5 s)
1) Read the barcode above to specify the desired beep active time.
2) Read the “Decimal Value
” barcode on page 錯誤! 尚未定義書籤。. For example, read “1”
and “5” for the pager beep function to be activated each 15 seconds after entering
Power-Saving mode.
3) Read the “Validate” barcode on the same page to complete this setting.