Specifications

36
Enter Setup
1704 Barcode Scanner User Guide
1.13.3 IMAGE MODE SETTINGS
Image Mode Timeout
Set the amount of time the decoder remains in Image Mode. The decoder exits Image Mode upon a
trigger event, or when the Image Mode Timeout elapses. By default, the time-out value is set to 0
which represents 30 seconds. Values increment by 30. For example, 1 = 60 seconds, 2 = 90
seconds, etc.
Image Mode Time-out
a
fter 30~ sec.
(*0)
1. Read the barcode above to specify the time interval before returning to Decode Mode. (It is
set to 0 by default.)
2. Read the “Decimal Value” barcode on page 211. For example, read “5” for the scanner to
automatically shut down after being idle for 180 seconds.
3. Read the “Validate” barcode on the same page to complete this setting.
Image Aiming Pattern
Decide whether to allow the decoder to project the aiming pattern in Image Mode.
*Enable
Disable
Video View Finder
Decide whether to enable Image Mode with View Finder, which the decoder behaves as a video
camera until a trigger event is activated.
Enable
*Disable
Select the number of 100-byte blocks. Values range from 800 to 3000 bytes. Selecting a smaller
value transmits more frames per second; selecting a larger value increases video quality.
Video View Finder
Image Size in 100
bytes 8~30 (*17)