User's Manual

Chapter 4

Define Output Format

[q]: Time Data Type in Field 5. Default = ‘5’

[r]: Time Data Type in Field 6. Default = ‘6’

[s]: Time Data Type in Field 7. Default = ‘7’

ERR,[code]\r

Example:

Note: If the parameter for field is set to ‘0’, the separator will also be ignored.

Time Stamp Separators

You can configure the separator between field and field with hexadecimal or character. Refer

to ASCII Table.

Command:

#@dat_tsprh?\r, #@dat_tspr?\r

Purpose Get the Separators of Field in Time Stamp Section

Request #@dat_tsprh?\r //Response data will be shown in Hexadecimal value.

#@dat_tspr?\r //Response data will be shown in character.

Response OK,[m],[n],[o],[p],[q],[r]\r

[m]: separator between field1 and field2. Default= ‘2D’ (‘-’)

[n]: separator between field2 and field3. Default= ‘2D’ (‘-’)

[o]: separator between field3 and field4. Default= ‘20’ (‘ ’)