User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
88
1800 Series Handheld RFID Reader Reference Manual
9) In the Bluetooth
®
Devices configured window will show you connected Device.
Note: When any changes are made to authentication and PIN code on the RFID Reader,
or you want to change to use Bluetooth
®
HID, it is suggested to remove the
connected RFID Reader from the paired device list (called unpairing) first and go
through the whole process to re-establish the connection.
10) Run the desired application on host computer, such as HyperTerminal.exe if using Bluetooth
®
SPP or Notepad.exe if using Bluetooth
®
HID.
Once the desired application is configured completely, the status of the RFID Reader listed on
the device list will be showed as “Connected”, indicating the WPAN connection is established
successfully.