User's Manual

89
Chapter 3 Settin
g
Up a WPAN Connection
3.2 CONNECTING VIA 3610
3.2.1 CONNECT TO 3610
To configure 3610 connection parameters, the RFID reader must have established a
Bluetooth
®
connection with 3610. Thus please carry out “#@bt_target=1,xxxxxxxxx\r”
command to establish the connection between them. Once connected, the RFID Reader
will respond with three beeps (tone ascending from low to high), and the LED2 flashes
blue (On/Off ratio 0.02 s: 3 s). When out of range, the RFID Reader will respond with
three short beeps (tone descending from high to low).
3.2.2 USB HID VIA 3610 CONNECTION
If you want to change the USB HID via 3610 interface, use one of the connected RFID
Reader to configure the interface-related settings and it will pass the new settings to
3610, which will then initialize and pass the settings to any other connected device.
1) Power on RFID Reader.
2) Connect RFID Reader to host computer with a USB cable.
3) Enable HyperTerminal on the host computer for issuing commands.
4) Follow
Using HyperTerminal to make a USB connection between the host computer
and RFID Reader.
5) Follow
2.6 USB VCOM and HID via 3610 to connect 3610 to the USB port of host
computer. And then make a connection between RFID Reader and 3610.
6) After the connection between RFID Reader and 3610 is established, configure related
settings as below.