User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
90
1800 Series Handheld RFID Reader Reference Manual
Command
#@bt_aclidx=0 → enter 3610 type configuration
Response (s)
OK
Command
#@bt_aclpr=97 → set to 3610 PCAT US
Response (s)
OK
Command
#@bt_aclidx=4 → enter inter-character delay setting
Response (s)
OK
Command
#@bt_aclpr=10 → set keyboard inter-character delay time to 10ms
Response (s)
OK
Command
#@bt_aclact → activate the settings
Response (s)
OK
7) After the “#@bt_aclact” command is performed, the connection between RFID Reader
and 3610 will disconnect for a while. Once the connection resumes, the interface of
3610 is updated to USB HID.
8) For USB HID via 3610 connection, you can capture the data by running any text
editor, e.g. NotePad on host computer.
9) Once the connection is successful, the scanned data will be transmitted to the
NotePad.