User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
93
Equipped with a switch in the handle, the RFID Reader allows you to toggle between
RFID and Alternate modes. Make sure the switch is well-positioned before taking on RFID
scanning tasks. You can also get the status between RFID and Alternate modes by
issuing the “#@rf_switch?” command.
Command:
#@rf_switch?\r
Purpose Get the Status between RFID and Alternate Mode
Response
OK,[m]\r (Default m= ‘1’)
[m]: Status of RFID/EXT Switch
‘0’ – EXT Mode (Alternate Mode)
‘1’ – RFID Mode
ERR,[code]\r
IN THIS CHAPTER
4.1 Scan Mode................................................................ 94
4.2 Scan Time ................................................................ 96
4.3 Filter........................................................................ 98
4.4 Multi-Tag.................................................................110
4.5 Access Tag .............................................................114
4.6 Advanced Settings ....................................................121
Chapter 4
SCANNING UHF RFID TAG