User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
95
Chapter 4
SCANNING UHF RFID
Ta
g
3. Scan Session Timeout, Scanning Delay, Multi-Tag Counter and EPC filter
parameters have no effect in this mode.
4. If RFID Function=Write Tag Memory, the RFID Reader can not be set to Test
Mode.
Command:
#@rf_scan?\r
Purpose Get Scan Mode
Response
OK,[m]\r (Default m= ‘6’)
[m]: Scan Mode
‘6’ – Single Mode
‘7’ – Test Mode
‘9’ – Multi – Tag Mode, refer to
4.4 Multi-Tag.
ERR,[code]\r
#@rf_scan=[m]\r
Purpose Set Scan Mode
Response OK\r
ERR,[code]\r