User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
97
Chapter 4
SCANNING UHF RFID
Ta
g
4.2.2 DELAY TIME
You can specify the scanning delay time when the scan mode is set to Multi-Tag Mode.
Command:
#@rf_scandly?\r
Purpose Get Scan Delay
Response
OK,[m]\r (Default m= ‘0’)
[m]: Scan Delay
‘0’ 100ms
‘1’ 200ms
‘2’ 400ms
‘3’ 800ms
‘4’ 1 sec
‘5’ 2 sec
‘6’ 3 sec
‘7’ 5 sec
ERR,[code]\r
#@rf_scandly=[m]\r
Purpose Set Scan Delay
Response OK\r
ERR,[code]\r