User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
103
Chapter 4
SCANNING UHF RFID
Ta
g
EPC Pattern
Define the hexadecimal pattern that is used to be compared.
Command:
#@rf_sepcpt?\r
Purpose Get Included EPC Pattern
Response OK,[m]\r (Default m= ‘00’)
[m]: EPC pattern in hexadecimal value.
ERR,[code]\r
#@rf_sepcpt=[m]\r
Purpose Set Included EPC Pattern
Response OK\r
ERR,[code]\r
#@rf_sepcpt2?\r
Purpose Get Included EPC2 Pattern
Response OK,[m]\r (Default m= ‘00’)
[m]: EPC pattern in hexadecimal value.
ERR,[code]\r
#@rf_sepcpt2=[m]\r
Purpose Set Included EPC2 Pattern
Response OK\r
ERR,[code]\r
State
Disable or Enable Included EPC Filter function. When the value is set to ‘1’, Tag EPC will be accepted
upon fitting the required pattern. If the value is set to ‘2’, Tag EPC will be accepted between pattern
and pattern2. (Pattern<=Tag EPC<=Pattern2).
Command:
#@rf_sepcen?\r
Purpose Get Included EPC State
Response OK,[m]\r (Default m= ‘0’)
[m]: ‘0’ – disable, ‘1’ – enable, ‘2’ – enable range filter
ERR,[code]\r