User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
119
Chapter 4
SCANNING UHF RFID
Ta
g
Command
#@rf_rwpr=0 → to read the whole bank
Response (s)
OK
Command
#@rf_func=0 → inventory
Response (s)
OK
1. 12-09-07 10:22 07.91
30003515fd8560082350000000066d36
→ after pressing the trigger
Command
#@rf_func=1 → set function to read Tag memory
Response (s)
OK
2. 12-09-07 10:22 46.85
30003515fd8560082350000000066d36e2006001011fcdc5
→ after pressing the trigger
(the ‘e2006001011fcdc5’ string is Tag
ID)
Example (Write Tag Memory):
Command
#@rf_rwidx=1
Response (s)
OK
Command
#@rf_rwpr=3 → to write User Bank
Response (s)
OK
Command
#@rf_rwidx=2
Response (s)
OK
Command