User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
123
You may configure the format of the collected data being output to the host computer.
Data transmission of the tags read can have various formats. The following sections will
describe the available options.
1) Decide the output format.
2) Define the data fields for Time stamp, Data Count and Data sections.
3) Set separators for each section.
4) Define output length of the data.
5) Add
Prefix Code and Suffix Code before transmission.
6) Decide the output sequence of Time stamp, Data Count and Data sections.
IN THIS CHAPTER
5.1 Output Format..........................................................124
5.2 Format Editing for Hexadecimal and Raw Data ..............126
5.3 Prefix/Suffix Code .....................................................142
5.4 Output EPC Data via USB Virtual COM..........................145
Chapter 5
DEFINING OUTPUT FORMAT