User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
129
Chapter 5
DefinING Output Format
Example:
Command
#@dat_rstcnt? → get the values of reset counter events
Response (s)
OK,1,1,1
26. 04-13-2012 30003430333130303132303030304221
Command
#@dat_rstcnt → run the reset counter command
Response (s)
OK
1. 04-13-2012 30003430333130303132303030304221 → re-count
2. 04-13-2012 30003430333130303132303030304221
3. 04-13-2012 30003430333130303132303030304221