User's Manual

133
Chapter 5 DefinING Output Format
Time Stamp Separators
You can configure the separator between fields. The separator to be configured or
retrieved can present in ASCII characters or hexadecimal numbers. Refer to
ASCII Table
Command:
#@dat_tsprh?\r, #@dat_tspr?\r
Purpose Get the Separators of Field in Time Stamp Section
Request #@dat_tsprh?\r //Response data will be shown in Hexadecimal value.
#@dat_tspr?\r //Response data will be shown in character.
Response OK,[m],[n],[o],[p],[q],[r]\r
[m]: separator follows field1. Default= ‘2D’ (‘-’)
[n]: separator follows field2. Default= ‘2D’ (‘-’)
[o]: separator follows field3. Default= ‘20’ (‘ ’)
[p]: separator follows field4. Default= ‘20’ (‘ ’)
[q]: separator follows field5. Default= ‘3A’ (‘:’)
[r]: separator follows field6. Default= ‘20’ (‘ ’)
ERR,[code]\r
#@dat_tspr=[m],[n],[o],[p],[q],[r],[s]\r
Purpose Set the Separators of Field in Time Stamp Section
Request #@dat_tspr=[m],[n],[o],[p],[q],[r],[s]\r
[m]: input data format, ‘0’- in Hexadecimal, ‘1’- in character
[n]: separator follows field1
[o]: separator follows field2
[p]: separator follows field3
[q]: separator follows field4
[r]: separator follows field5
[s]: separator follows field6
Response OK\r
ERR,[code]\r
Note: Input ‘00’ (hexadecimal) to clear the inputted data.