User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
134
1800 Series Handheld RFID Reader Reference Manual
Example:
Command
#@dat_tseq=1,2,3,4,5,6,7 → enable all fields
Response (s)
OK
19. 2012-04-12 Thu 23:04 08.34 30003430333130303132303030304221
Command
#@dat_tsprh? → get the separators with hexadecimal format
Response (s)
OK,2d,2d,20,20,3a,20
Command
#@dat_tspr? → get the separators with character format
Response (s)
OK,-,-, , ,:,
Command
#@dat_tspr=0,3a,3a,00,00,00,00 → reset the separators with hexadecimal format
Response (s)
OK
20. 2012:04:12Thu230557.61 30003430333130303132303030304221
Command
#@dat_tspr=1,/,/, ,/,/,/ → reset the separators with character format
Response (s)
OK
20. 2012/04/12 Thu/23/06/34.61 30003430333130303132303030304221