User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
136
1800 Series Handheld RFID Reader Reference Manual
Time
You can enable this function to display time in seconds with the scale of two digits to the
right of the decimal point if second field is enabled.
Command:
#@dat_tms?\r
Purpose Get Time Format
Response OK,[m]\r (Default m= ‘1’)
[m]: Display time in seconds with two digits after the decimal point.
0 – Disable, 1 – Enable
ERR,[code]\r
#@dat_tms=[m]\r
Purpose Set to Display Time
Request #@dat_tms=[m]\r
[m]: Display time in seconds with two digits after the decimal point.
0 – Disable, 1 – Enable
Response OK\r
ERR,[code]\r
Example:
Command
#@dat_tms? → get the displaying format of seconds
Response (s)
OK,1
5. 2012-04-12 05:44 59.47 30003430333130303132303030304221
display↑ time in seconds with two digits after the decimal point
Command
#@dat_tms=0 → set to display time in seconds without decimals
Response (s)
OK
6. 2012-04-12 05:44 59 30003430333130303132303030304221