User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
141
Chapter 5
DefinING Output Format
Command
#@dat_rflen? → get the RFID data length setting
Response (s)
OK,0
35. 2012-04-12 Fri 04:00 55.95 3430333130303132303030303000422116
→ display total data length
Command
#@dat_rflen=1 → change the value to 1 displaying the EPC length only
Response (s)
OK,2,3,1,4,5
36. 2012-04-12 Fri 04:00 55.95 3000343033313030313230303030422112
→ EPC data length is 12 bytes
Command
#@dat_rflen=2
→ change the value to 2 displaying the Memory data
length only
Response (s)
OK
37. 2012-04-12 Fri 04:00 55.95 300034303331303031323030303042210
→ fail to read the Tag Memory data so the data length is 0