User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
5
Introduction
CHARGING THE BATTERY VIA CHARGER
Batteries may also be charged through the battery charger rather than in the reader
itself, allowing the user to continue using the reader at all times.
1) Connect the power supply cord to the power port located on the back of the charger.
2) Insert the battery to the end.
3) Confirm the lock bolt locks the battery securely.
4) Connect the other end of the power cord to a suitable power outlet.
5) Once the power and battery are ready, the LED indicator lights.
6) After finishing charge, press down the lock bolt to pull out the battery.
Status LED
Function
Blue, Solid Charger power ON
Red, Solid Charging battery
Green, Solid Charging done
Blue/Red Ratio 0.5s:0.5s Error
Note: Battery charging stops when the temperature drops below 0°C or exceeds 40°C. It
is recommended to charge the battery at room temperature (18°C to 25°C) for
optimal performance.