User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
7
POWER ON RFID READER
Be sure the battery is fully charged before you power on the RFID Reader. Press the
trigger for 2 seconds to power on the RFID Reader. The reader will respond with a long
beep (high tone), and LED1 will become solid red for 1 second and go off.
Note: The LED2 will flash blue when you power on the RFID Reader successfully.
CONNECTING USB CABLE
1) The RFID Reader has a built-in USB port enabling its connection to host computers for
configuration and data transmission.
2) Remove the USB port cover.
3) Connect the USB communication cable to USB port. (USB logo shall face down)
4) Connect the other end of USB cable to the host computer.
QUICK START