User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
27
Chapter 1
Understandin
g
RFID Reader
1.2.2 MEMORY MODE
The RFID Reader includes 4MB flash memory for data storage when the reader operates
in memory mode. When the RFID Reader gets into memory mode, the current
Bluetooth
®
connection with the host is disabled.
Warning: Bluetooth
®
connection is not available in the memory mode.
STATUS
Confirm the memory size by issuing “#@sys_memsize?” command.
Command:
#@sys_memen?\r
Purpose Get Memory Mode Status
Response OK,[m]\r (Default m= ‘0’)
[m]: ‘0’ – Disable
‘1’ – Enable
ERR,[code]\r
#@sys_memen=[m]\r
Purpose Set Memory Mode
Response OK\r
ERR,[code]\r
Note: You can also enter/exit memory mode by pressing function keys. Refer to 1.3.1.2
Functions.
#@sys_memsize?\r
Purpose Get Free Memory Size
Response OK,[m]\r (Max. 4072)
[m]: Free Memory Size string in KB
ERR,[code]\r