User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
50
1800 Series Handheld RFID Reader Reference Manual
2.3 BLUETOOTH
®
SPP SLAVE
For Bluetooth
®
SPP Slave, issue the “#@bt_type=” to parameter ‘0’ for output interface.
Then, refer to
Setting Up a WPAN Connection for related connection settings. By default,
RFID Reader connection type is configured to “SPP Slave”.
Example:
Command
#@bt_type? → get current Bluetooth
®
type
Response (s)
OK,0 → default Bluetooth
®
type is ‘0’ for SPP Slave
Command
#@bt_type=0 → set Bluetooth
®
type to SPP Slave
Response (s)
OK