User's Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING RFID READER
- COMMUNICATION INTERFACE
- SETTING UP A WPAN CONNECTION
- SCANNING UHF RFID TAG
- DEFINING OUTPUT FORMAT
- ALTERNATE MODE
- SPECIFICATIONS
- FIRMWARE UPGRADE
- ASCII TABLE
- SCAN CODE
- STATUS CODE
75
Chapter 3
Settin
g
Up a WPAN Connection
Purpose Get Bluetooth® PIN Code
Response OK,[m],[n]\r (Default m= ‘0000’, n= ‘4’)
[m]: length of PIN ‘0’ ~ ‘16’, ‘0’ means no PIN
[n]: PIN, 1~16 characters, only exists when [m]!= ‘0’ (m≠0)
ERR,[code]\r
#@bt_pin=[m],[n]\r
Purpose Set Bluetooth
®
PIN Code
Response OK\r
ERR,[code]\r
Note: When using Bluetooth
®
HID, some device driver may not support pre-defined PIN
code for authentication. In this case, make sure you have the RFID Reader set to
“No PIN required” or “User-specified PIN” before pairing. While pairing, the host
PIN code will be displayed on the host computer. Have the RFID Reader to input
the matching PIN code for connection. Refer to
1.3.2 Bluetooth® Pairing Mode.
User-specified PIN
No PIN re
q
uired