User Manual

158
Enter Setup
1660 Barcode Scanner
User Guide
HOW TO UPGRADE 3610 FIRMWARE
1) Connect 3610 to the USB port of PC. You may need to install its driver first!
2) Refer to 3.1.1 Connect to 3610
for the target scanner to connect to 3610.
Read the “Set Connection” label first, and then the “Serial Number” label within 5
seconds. Both labels can be located at the back of 3610. After reading these labels,
the scanner will stay active for 2 minutes trying to connect to 3610 while its LED is
flashing blue (On/Off ratio 0.5 s: 0.5 s). Once connected, the scanner will respond
with three beeps (tone ascending from low to high), and the LED becomes flashing
blue (On/Off ratio 0.02 s: 3 s).
3) Read the following labels in sequence to configure the scanner to use USB Virtual
COM as output interface.
4) Read the following labels in sequence for 3610 to enter the download mode. The
Communication LED on 3610 will be flashing red to indicate it is ready for
downloading.
Enter Setup
3610 Download CPU Firmware
3
610
D
ownload
U
SB Bridge Firmware
Enter Setup
Activate USB Virtual COM
U
pdate