User Manual

41
Update
In order to establish a proper connection between your computer and the scanner, we
suggest that you follow these instructions –
1) Install batteries and press the [Power/Delete] key for 3 seconds to turn on the
scanner.
2) Have the scanner read the “Enter Setup” label to enter the configuration mode.
3) Have the scanner read the associated label to activate the desired interface.
See the following sections for output interfaces supported.
4) Have the scanner read the labels for related settings.
5) Have the scanner read the “Update” label to exit the configuration mode.
6) Turn on your computer or laptop and establish a WPAN connection with the scanner.
Refer to Chapter 3 – Setting up a WPAN Connection
.
Note: By default, the output interface is set to “BT HID”.
IN THIS CHAPTER
2.1 BT HID ..................................................................... 42
2.2 BT SPP ..................................................................... 49
2.3 USB HID via 3610 ...................................................... 51
2.4 USB Virtual COM via 3610 ........................................... 58
Chapter 2
SELECTING OUTPUT INTERFACE