User Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING THE BARCODE SCANNER
- SELECTING OUTPUT INTERFACE
- SETTING UP A WPAN CONNECTION
- CHANGING SYMBOLOGY SETTINGS
- 4.1 CODABAR
- 4.2 CODE 25 – INDUSTRIAL 25
- 4.3 CODE 25 – INTERLEAVED 25
- 4.4 CODE 25 – MATRIX 25
- 4.5 CODE 39
- 4.6 CODE 93
- 4.7 CODE 128
- 4.8 EAN-8
- 4.9 EAN-13
- 4.10 GS1-128 (EAN-128)
- 4.11 ISBT 128
- 4.12 MSI
- 4.13 FRENCH PHARMACODE
- 4.14 ITALIAN PHARMACODE
- 4.15 PLESSEY
- 4.16 GS1 DATABAR (RSS FAMILY)
- 4.17 TELEPEN
- 4.18 UPC-A
- 4.19 UPC-E
- DEFINING OUTPUT FORMAT
- APPLYING FORMATS FOR DATA EDITING
- SPECIFICATIONS
- Appendix I - FIRMWARE UPGRADE
- Appendix II - HOST SERIAL COMMANDS
- Appendix III - KEYBOARD WEDGE TABLE
- Appendix IV - NUMERAL SYSTEMS
155
Update
Chapter 6
Applying Formats for Data Editin
g
You may specify a value from 0 to 254.
When zero is given to both, the scanner will not perform the length qualification.
1. Read the label below to specify Max. Length or Min. Length separately, and follow steps 2~3.
2. Read the “Decimal Value” label on page 187 for the desired length.
3. Read the “Validate” label on the same page to complete this setting.
Matching String & Location
By default, no matching string is specified, and therefore, it is disabled. You may enable this
feature by specifying a matching string; up to four characters are allowed.
When the Matching String Location is zero, the scanner will only check for the existence of the
matching string in the barcode data.
You may specify a value from 1 to 254 to indicate where the matching string starts in the
barcode data.
1. Read the label to specify a matching string.
2. Read the “Hexadecimal Value” label on page 188 for the desired character string.
3. Read the “Validate” label to complete this setting.
4. Read the label to specify the location of the matching string.
5. Read the “Decimal Value” label on page 187 for the desired location.
6. Read the “Validate” label on the same page to complete this setting.
Max. Length
Min. Length
Matching String …
Location of
Matching String …