User Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING THE BARCODE SCANNER
- SELECTING OUTPUT INTERFACE
- SETTING UP A WPAN CONNECTION
- CHANGING SYMBOLOGY SETTINGS
- 4.1 CODABAR
- 4.2 CODE 25 – INDUSTRIAL 25
- 4.3 CODE 25 – INTERLEAVED 25
- 4.4 CODE 25 – MATRIX 25
- 4.5 CODE 39
- 4.6 CODE 93
- 4.7 CODE 128
- 4.8 EAN-8
- 4.9 EAN-13
- 4.10 GS1-128 (EAN-128)
- 4.11 ISBT 128
- 4.12 MSI
- 4.13 FRENCH PHARMACODE
- 4.14 ITALIAN PHARMACODE
- 4.15 PLESSEY
- 4.16 GS1 DATABAR (RSS FAMILY)
- 4.17 TELEPEN
- 4.18 UPC-A
- 4.19 UPC-E
- DEFINING OUTPUT FORMAT
- APPLYING FORMATS FOR DATA EDITING
- SPECIFICATIONS
- Appendix I - FIRMWARE UPGRADE
- Appendix II - HOST SERIAL COMMANDS
- Appendix III - KEYBOARD WEDGE TABLE
- Appendix IV - NUMERAL SYSTEMS
159
Update
Chapter 6
Applying Formats for Data Editin
g
Field 2 Setting
1. Read the above label to divide field by a specified terminating string.
2. Read the “Hexadecimal Value” label on page 188 for the desired character string.
3. Read the “Validate” label to complete this setting.
4. Read the “Discard Separator” label if the field separator is not desired in the field.
If not dividing the field by a specific separator, you may divide it by a specified length.
1. Read the above label to divide field by length.
2. Read the “Decimal Value” label on page 187 for the desired field length.
3. Read the “Validate” label on the same page to complete this setting.
Select Field Separator
to Divide Field 2 …
*Include Separator
D
iscard Separator
Divide Field 2 by Length …