User Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING THE BARCODE SCANNER
- SELECTING OUTPUT INTERFACE
- SETTING UP A WPAN CONNECTION
- CHANGING SYMBOLOGY SETTINGS
- 4.1 CODABAR
- 4.2 CODE 25 – INDUSTRIAL 25
- 4.3 CODE 25 – INTERLEAVED 25
- 4.4 CODE 25 – MATRIX 25
- 4.5 CODE 39
- 4.6 CODE 93
- 4.7 CODE 128
- 4.8 EAN-8
- 4.9 EAN-13
- 4.10 GS1-128 (EAN-128)
- 4.11 ISBT 128
- 4.12 MSI
- 4.13 FRENCH PHARMACODE
- 4.14 ITALIAN PHARMACODE
- 4.15 PLESSEY
- 4.16 GS1 DATABAR (RSS FAMILY)
- 4.17 TELEPEN
- 4.18 UPC-A
- 4.19 UPC-E
- DEFINING OUTPUT FORMAT
- APPLYING FORMATS FOR DATA EDITING
- SPECIFICATIONS
- Appendix I - FIRMWARE UPGRADE
- Appendix II - HOST SERIAL COMMANDS
- Appendix III - KEYBOARD WEDGE TABLE
- Appendix IV - NUMERAL SYSTEMS
173
Update
Appendix I Firmware Upgrade
USING A GENERIC DONGLE
1) Refer to 43.2.3 Connect to Dongle for the target scanner to accept the connection
request from your computer.
2) Read the following labels in sequence to configure the scanner to use BT SPP as
output interface.
3) Read the following labels in sequence for the scanner to enter the download mode.
The scanner will respond with beeps to indicate it is ready for downloading.
4) Run the download utility “ProgLoad.exe” on your computer.
1. For the communication settings, select “RS-232” and the correct COM port for BT
SPP interface, and ignore the baud rate setting.
2. For the file option, click [Browse] to select the target file for firmware update —
Kernel (K*.shx) or user program (STD*.shx).
3. Click [OK].
E
nter Setup
Activate BT SPP
(and read labels for PIN code …)
U
pdate
E
nter Setup
D
ownload