User Manual

24
Enter Setup
1560 Series Barcode Scanner User Guide
1.4 BEEPER
The scanner has a buzzer to provide user feedback in various operating conditions.
Beeping
Meaning
One long beep, high tone Power on, with red LED on (1 second) and off quickly
One short beep, high tone
(programmable, default to 4 KHz)
Good Read, with green LED on and off quickly
Six short beeps, high-low tone
repeats three times
 Enter Configuration Mode, with red LED flashing
 Exit Configuration Mode
Two short beeps, low-high tone Setup label read successfully
One short beep, high tone
 More setup label required
 Input PIN code
 Clear PIN code
One short beep, low tone More barcodes required to complete the “output sequence”
requirements of Multi-Barcode Editor, with green LED on
and off quickly (Upon completion, same as Good Read.)
One long beep, low tone
 Transmit buffer full, with red LED on and off quickly
 Transmit buffer disabled, with red LED on and off
quickly
 Configuration error (Wrong label…)
 PIN code input error
 Reject random PIN request
 Fail to send data in memory mode
Two short beeps, high-low tone
 Data saved to buffer when transmit buffer is enabled
and the scanner is out of range, with red LED on and off
quickly
 Memory Mode – Memory full, with red LED on and off
quickly
Two long beeps, high-low tone Multi-Barcode Mode – Buffer full
Three short beeps, tone ascending
from low to high
 WPAN connection established, with blue LED flashing
 WPAN connection resumed, with blue LED flashing
Three short beeps, tone ascending
from high to low
WPAN connection out of range or suspended