User Manual
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- QUICK START
- UNDERSTANDING THE BARCODE SCANNER
- SELECTING OUTPUT INTERFACE
- SETTING UP A WPAN CONNECTION
- CHANGING SYMBOLOGY SETTINGS
- 4.1 CODABAR
- 4.2 CODE 25 – INDUSTRIAL 25
- 4.3 CODE 25 – INTERLEAVED 25
- 4.4 CODE 25 – MATRIX 25
- 4.5 CODE 39
- 4.6 CODE 93
- 4.7 CODE 128
- 4.8 EAN-8
- 4.9 EAN-13
- 4.10 GS1-128 (EAN-128)
- 4.11 ISBT 128
- 4.12 MSI
- 4.13 FRENCH PHARMACODE
- 4.14 ITALIAN PHARMACODE
- 4.15 PLESSEY
- 4.16 GS1 DATABAR (RSS FAMILY)
- 4.17 TELEPEN
- 4.18 UPC-A
- 4.19 UPC-E
- DEFINING OUTPUT FORMAT
- APPLYING FORMATS FOR DATA EDITING
- SPECIFICATIONS
- Appendix I - FIRMWARE UPGRADE
- Appendix II - HOST SERIAL COMMANDS
- Appendix III - KEYBOARD WEDGE TABLE
- Appendix IV - NUMERAL SYSTEMS
51
Update
Chapter 2
Selecting Output Interface
2.2 BT SPP
For BT SPP, refer to Chapter 3 – Setting up a WPAN Connection for related connection
settings. For example, run HyperTerminal.exe on your computer, and the scanned data
will be transmitted to the computer.
2.2.1 ACTIVATE BT SPP
2.2.2 INTER-FUNCTION DELAY
By default, the inter-function delay is set to zero. Specify a value, ranging from 0 to 254,
to match the computer response time of the keyboard interface. Such delay time is
inserted between every function code (0x01 ~ 0x1F) being transmitted. The longer the
delay time is, the slower the transmission speed will be.
Value
Delay Time Value Delay Time
0 Disable 195 ~ 204 200 millisecond
1 ~ 14 10 millisecond 205 ~ 214 210 millisecond
15 ~ 24 20 millisecond 215 ~ 224 220 millisecond
25 ~ 34 30 millisecond 225 ~ 234 230 millisecond
35 ~ 44 40 millisecond 235 ~ 244 240 millisecond
45 ~ 54 50 millisecond 245 ~ 254 250 millisecond
… …
1) Read the label above to specify the inter-function delay.
2) Read the “Decimal Value
” label on page 187 for the desired inter-function delay
(millisecond).
3) Read the “Validate” label on the same page to complete this setting.
Activate Bluetooth SPP
Inter-Function Delay … (*0 ~ 25
4
)