User's Manual

• Checksum Transmission: If this parameter is enabled, the checksum

characters (two characters) will be transmitted together with data.

5.11 Telepen

• Telepen Output: There are two flavors of encoding formats for Telepen.

One is the original Telepen format, the other is AIM Telepen format. User

can choose the desired encoding format for Telepen readings.

5.12 RSS

• Code ID Selection: User has choice of using RSS Code ID (‘]e0’) or

EAN128 Code ID (‘]C1’).

• Code ID Transmission: If this parameter is enabled, the Code ID selected

by the preceding setting will be included in the data being transmitted.

• Application ID Transmission: If this parameter is enabled, the Application

ID will be included in the data being transmitted.

• Checksum Transmission: If this parameter is enabled, the checksum

character will be transmitted together with data.

6. Data Output Format

Data read by the scanner will be processed in the following sequence (RS-232,

Keyboard Wedge and USB interfaces).

1) The character substitution is performed on the barcode data.

2) The Code ID and the Length Code are inserted at the beginning of the data as

shown below.

[Code ID] [Length Code] [Data]

3) The resulting data of step 1 will be processed by the editing formats. For details,

please refer to the section “Data Editing”.

4) And finally the Prefix Code and the Postfix Code will be added before

transmission.

[Prefix Code] [Resulting Data of Step 3] [Postfix Code]

6.1 Character Substitution

There are three character substitution settings on the scanner. These settings are

configured on a character base. That is, a specific character is to be substituted by

another character. The character substitution is performed on every occurrence of

the characters specified in these settings. Be aware, the substitution is performed

only on the barcode itself (exclude Prefix Code, Postfix Code, Code ID, Length

Code or any Additional Field) and is performed before editing mode processing.

If only the character to be replaced is specified, every occurrence of that character

in the barcode will be taken away.

6.2 Prefix / Postfix Code

Up to four characters of prefix / postfix code can be configured for the scanner.

6.3 Code ID

Up to two characters of Code ID can be configured for each symbology. To

minimize the Code ID configuration efforts, the scanner provides five predefined

Code ID Sets that user can select from. User can first select one of the Code ID

Sets and then make desired modifications. The pre-defined Code ID Sets are shown

below.