User's Manual

4.4.3 Send Data

This enables the user to transmit the data in the scanner’s memory to the host. The

interface selected by the user will be used for the transmission. During the

transmission the red LED of 1160 will be flashing.

4.4.4 Memory Data Delay

This will enable the user to set a delay between each data records in memory at

time of transmission.

5. Symbology Parameters

This section describes user configurable parameters that are pertaining to barcode

symbologies.

5.1 Code39

• Standard / Full ASCII Code 39 : User can choose to read either Standard

Code 39 or Full ASCII Code 39 by configuring this parameter.

• Start/Stop Transmission : This parameter specifies whether the start/stop

characters of Code 39 are included in the data being transmitted.

• Checksum Verification : This parameter specifies whether the scanner will

perform checksum verification when decoding barcodes. If the checksum is

incorrect, the barcode will not be read.

• Checksum Transmission : This parameter specifies whether the checksum

character are included in the data being transmitted.

5.2 Italy / French Pharmacode

For Italy /French Pharmacode, there is always a checksum character included in the

barcode. So the checksum verification is always performed when decoding these

symbologies. User though can choose whether the checksum character is to be

transmitted or not. The start / stop transmission of this code shares the same setting

of Code 39.

• Checksum Transmission: This parameter specifies whether the checksum

character is included in the data being transmitted.

5.3 Industrial / Interleave / Matrix 25

• Start / Stop Selection: This parameter provides the readability of all 2 of 5

symbology variants. For example, flight tickets actually use an Industrial 25

barcode but with Interleave 25 start / stop. In order to read this barcode, the

start / stop selection parameter of Industrial 25 should set to ‘Interleave

25.

• Checksum Verification: This parameter specifies whether the scanner will

perform checksum verification when decoding barcodes. If the checksum is

incorrect, the barcode will not be read.

• Checksum Transmission: This parameter specifies whether the checksum

character is included in the data being transmitted.

• Code Length Qualification: Because of the weak structure of the 2 of 5

codes, a partial scan has a high probability of decoding as a valid but shorter

2 of 5 codes (known as short scan). To prevent this kind of undesired

reading, the Code Length settings can help to insure that the correct code is