User's Manual

3G/GPRS Cradle

Reference Manual

Go through the following steps with each cradle:

7) Connect the power supply cord to a suitable power outlet.

Note: After powering on, the POWER indicator will become red. The TX/RX and LAN

indicators will flash in turn at the time interval of 0.25 seconds for 30 seconds,

indicating the cradle is in initialization process. Then, TX/RX indicator will keep on

flashing, indicating a failure in initialization due to lack of SIM card. Ignore it!

8) Seat the mobile computer in the cradle.

Go to 2. Settings | 4. Default Set to reset the cradle.

9) Disconnect the power supply cord.

10) Insert SIM card to the cradle.

11) Re-connect the power supply cord.

Note: After powering on, the POWER indicator will become red. The TX/RX and LAN

indicators will flash in turn at the time interval of 0.25 seconds for 30 seconds,

indicating the cradle is in initialization process. Then, the LEDs will flash differently

according to the status: (1) If the TX/RX indicator flashes, it means initialization

failed due to incorrect PIN; (2) If the LAN indicator flashes, it means initialization

is done successfully, either with correct PIN or PIN not required at all.

12) Go to 2. Settings | 3. Download to download your settings to the cradle.