User's Manual

Chapter 3

Using 8000 to Configure 3G/GPRS Cradle

13) Disconnect the power supply cord.

14) Re-connect the power supply cord.

Note: After powering on, the POWER indicator will become red. The TX/RX and LAN

indicators will flash in turn at the time interval of 0.25 seconds for 30 seconds,

indicating the cradle is in initialization process. Then, the LEDs will flash differently

according to the status: (1) If the TX/RX indicator flashes, it means initialization

failed due to incorrect PIN; (2) If the LAN indicator flashes, it means initialization

is done successfully, either with correct PIN or PIN not required at all.

15) Perform echo tests if necessary.