Product Info
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- USING 4G CRADLE
- HOW MODEM MODE WORKS
- USING 8001 TO CONFIGURE 4G CRADLE
- 15
- 16
- 17
- 3.1 DETECT BAUD RATE
- 18
- 3.2 VIEW THE SETTINGS
- 3.2.1 PREVIEW THE NEW SETTINGS
- 19
- 3.2.2 VIEW THE CURRENT CRADLE SETTINGS
- 3.2.3 VIEW IMEI INFORMATION
- 20
- 3.3 CONFIGURE SETTINGS
- 3.3.1 AUTHENTICATION
- 3.3.2 PIN CODE
- 21
- 3.4 DOWNLOAD SETTINGS
- 3.4.1 DOWNLOAD OK
- 22
- 3.4.2 DOWNLOAD FAIL — INCORRECT PIN
- 3.4.3 DOWNLOAD FAIL — PUK REQUIRED
- 3.4.4 RESET TO DEFAULTS
- 23
- 3.5 TESTING
- UPGRADING FIRMWARE
- SPECIFICATIONS
Introduction
INSTALLATION
1)
Remove the rubber cover at the back of the cradle.
2)
Insert your SIM card and replace the rubber cover.
The SIM card orientation is as shown in the illustration below, with contacts facing
down. Refer to Chapter 3 Using 8001 to Configure 4G Cradle.
3)
Seat the mobile computer in the cradle.
4)
Connect the power supply cord to a suitable power outlet, and the cradle’s POWER
indicator will become red. The cradle is ready for charging the mobile computer.
Note: You need to take out your SIM card when it is not in use. Always disconnect the
power supply before removing the SIM card.
3