Product Info
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- USING 4G CRADLE
- HOW MODEM MODE WORKS
- USING 8001 TO CONFIGURE 4G CRADLE
- 15
- 16
- 17
- 3.1 DETECT BAUD RATE
- 18
- 3.2 VIEW THE SETTINGS
- 3.2.1 PREVIEW THE NEW SETTINGS
- 19
- 3.2.2 VIEW THE CURRENT CRADLE SETTINGS
- 3.2.3 VIEW IMEI INFORMATION
- 20
- 3.3 CONFIGURE SETTINGS
- 3.3.1 AUTHENTICATION
- 3.3.2 PIN CODE
- 21
- 3.4 DOWNLOAD SETTINGS
- 3.4.1 DOWNLOAD OK
- 22
- 3.4.2 DOWNLOAD FAIL — INCORRECT PIN
- 3.4.3 DOWNLOAD FAIL — PUK REQUIRED
- 3.4.4 RESET TO DEFAULTS
- 23
- 3.5 TESTING
- UPGRADING FIRMWARE
- SPECIFICATIONS
Chapter 2 How Modem Mode
AT+DLMT= Set the delimiter check, enable or disable. √
AT+APN? Get the Access Point Name (APN) currently in
use.
√
AT+APN= Set the Access Point Name (APN) you want to
connect to.
√
AT+CHAP? Get the Challenge-Handshake Authentication
Protocol (CHAP) setting.
√
AT+CHAP= Set the Challenge-Handshake Authentication
Protocol (CHAP) setting, enable or disable.
√
AT+DHCP? Get the Dynamic Host Configuration Protocol
(DHCP) setting.
√
AT+DHCP= Set the Dynamic Host Configuration Protocol
(DHCP) setting, enable or disable.
√
AT+IP? Get the fixed IP address of the cradle.
√
AT+IP= Set the fixed IP address of the cradle.
√
AT+PSW? Get the password for Challenge-Handshake
Authentication Protocol (CHAP).
√
AT+PSW= Set the password for Challenge-Handshake
Authentication Protocol (CHAP).
√
AT+USER? Get the user name for Challenge-Handshake
Authentication Protocol (CHAP).
√
AT+USER= Set the user name for Challenge-Handshake
Authentication Protocol (CHAP).
√
13