Product Info
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- USING 4G CRADLE
- HOW MODEM MODE WORKS
- USING 8001 TO CONFIGURE 4G CRADLE
- 15
- 16
- 17
- 3.1 DETECT BAUD RATE
- 18
- 3.2 VIEW THE SETTINGS
- 3.2.1 PREVIEW THE NEW SETTINGS
- 19
- 3.2.2 VIEW THE CURRENT CRADLE SETTINGS
- 3.2.3 VIEW IMEI INFORMATION
- 20
- 3.3 CONFIGURE SETTINGS
- 3.3.1 AUTHENTICATION
- 3.3.2 PIN CODE
- 21
- 3.4 DOWNLOAD SETTINGS
- 3.4.1 DOWNLOAD OK
- 22
- 3.4.2 DOWNLOAD FAIL — INCORRECT PIN
- 3.4.3 DOWNLOAD FAIL — PUK REQUIRED
- 3.4.4 RESET TO DEFAULTS
- 23
- 3.5 TESTING
- UPGRADING FIRMWARE
- SPECIFICATIONS
4G Cradle Reference Manual
Go through the following steps with each cradle:
7)
Connect the power supply cord to a suitable power outlet.
Note: After powering on, the POWER indicator will become red. The TX/RX and LAN
indicators will flash in turn at 0.25-second time intervals for 60 seconds, indicating
the cradle is in initialization process. Then, TX/RX indicator will keep on flashing,
indicating a failure in initialization due to lack of SIM card. Ignore it!
8)
Seat the mobile computer in the cradle.
Go to 2. Settings | 4. Default Set to reset the cradle.
9)
Disconnect the power supply cord.
10)
Insert SIM card to the cradle.
11)
Re-connect the power supply cord.
Note: After powering on, the POWER indicator will become red. The TX/RX and LAN
indicators will flash in turn at 0.25-second time intervals for 60 seconds, indicating
the cradle is in initialization process. Then, the LEDs will flash differently according
to the status: (1) If the TX/RX indicator flashes, it means initialization failed due to
incorrect PIN; (2) If the LAN indicator flashes, it means initialization is done
successfully, either with correct PIN or PIN not required at all.
12)
Go to 2. Settings | 3. Download to download your settings to the cradle.
16