Product Info
Table Of Contents
- IMPORTANT NOTICES
- RELEASE NOTES
- INTRODUCTION
- USING 4G CRADLE
- HOW MODEM MODE WORKS
- USING 8001 TO CONFIGURE 4G CRADLE
- 15
- 16
- 17
- 3.1 DETECT BAUD RATE
- 18
- 3.2 VIEW THE SETTINGS
- 3.2.1 PREVIEW THE NEW SETTINGS
- 19
- 3.2.2 VIEW THE CURRENT CRADLE SETTINGS
- 3.2.3 VIEW IMEI INFORMATION
- 20
- 3.3 CONFIGURE SETTINGS
- 3.3.1 AUTHENTICATION
- 3.3.2 PIN CODE
- 21
- 3.4 DOWNLOAD SETTINGS
- 3.4.1 DOWNLOAD OK
- 22
- 3.4.2 DOWNLOAD FAIL — INCORRECT PIN
- 3.4.3 DOWNLOAD FAIL — PUK REQUIRED
- 3.4.4 RESET TO DEFAULTS
- 23
- 3.5 TESTING
- UPGRADING FIRMWARE
- SPECIFICATIONS
UPGRADING FIRMWARE
Chapter 4
4.1 DOWNLOAD VIA MOBILE COMPUTER
The 4G Cradle allows you to upgrade firmware via the mobile computer. When firmware
upgrade is available, download the utility “8000Deploy4G.shx” to your mobile computer.
Warning: DO NOT upgrade firmware unless the version of firmware is newer than
that your cradle has. For information of the current firmware version,
check AT commands.
1)
Download the utility “8000Deploy4G.shx” to your mobile computer.
The mobile computer will display a selection menu.
2)
On your mobile computer, select F/W Upgrade.
3)
Seat the mobile computer in the cradle.
4)
You may see this error message when the mobile computer is not properly seated in
the cradle. Please try again!
Warning: Before completing the download, do not disconnect the power cord or
remove the mobile computer from the cradle!
27