User's Manual

¾ Net Menu > Information
Information of network configuration can be viewed here.
 MAC: MAC ID of the 802.11b module
 DHCP: DHCP being enabled or disabled
 IP: IP address of the terminal
 Mask: Subnet Mask
 Gate: Default Gateway
¾ Net Menu > IP Setting
Set general network parameters.
 DHCP:
Options - Enable or Disable
 SubNet Mask:
Enter a new Mask IP, if necessary.
 Local IP Address:
Enter a new address for the terminal, if necessary.
 Default Gateway:
Enter a new address for the default Gateway, if
necessary.
 DNS Server:
Enter a new address for the DNS server, if necessary.
 Domain Name:
The domain name of the host is shown here.
Note: All of the setting could be obtained form DHCP server if DHCP is activated.
¾ Net Menu > WLAN Setting
802.11b system can operate in two modes (1) Ad-hoc mode: peer-to-peer, and (2)
Infrastructure mode: point to multi-point through access points.
Set the following parameters.
 Local Name:
Enter a name for identifying the terminal.
 Domain Name:
The domain name of the host is shown here.
 SS ID:
This refers to Service Set ID or Identifier.
The terminal can ONLY communicate with access
points that have the same SS ID
 System Scale:
This refers to Access Point Density.
Options - [1] Low [2] Medium [3] High