User's Manual
Table Of Contents
- Copyright Notice
- FCC Regulations
- Care & Maintenance
- Getting Started
- Preface
- CHAPTER 1: Introducing CPT-8500
- CHAPTER 2: Installing CPT-8500
- CHAPTER 3: Software Architecture
- CHAPTER 4: Configuring CPT-8500
- CHATPER 5: Managing CPT-8500
- Specifications
- Troubleshooting
- Appendix I - Download Utilities
- Index
Chapter 4 Configuring CPT-8500 63
¾ 802.11b Menu > Information
Information of network configuration can be viewed here.
MAC: MAC ID of the 802.11b module
DHCP: DHCP being enabled or disabled
IP: IP address of the terminal
Mask: Subnet Mask
Gate: Default Gateway
¾ 802.11b Menu > Network Setting
Set general network parameters.
DHCP:
Options - Enable or Disable
SubNet Mask:
Enter a new Mask IP, if necessary.
Local IP Address:
Enter a new address for the terminal, if necessary.
Default Gateway:
Enter a new address for the default Gateway, if
necessary.
DNS Server:
Enter a new address for the DNS server, if necessary.
Domain Name:
The domain name of the host is shown here.
Note: All of the setting could be obtained form DHCP server if DHCP is activated.