User's Manual
Table Of Contents
- Copyright Notice
- FCC Regulations
- Care & Maintenance
- Getting Started
- Preface
- CHAPTER 1: Introducing CPT-8500
- CHAPTER 2: Installing CPT-8500
- CHAPTER 3: Software Architecture
- CHAPTER 4: Configuring CPT-8500
- CHATPER 5: Managing CPT-8500
- Specifications
- Troubleshooting
- Appendix I - Download Utilities
- Index
24 Industrial CPT-8500 Reference Manual
Figure 8: Installing battery pack
2.2 Hand Strap
When a hand strap is necessary, install it to the terminal by following the steps:
1 Place the terminal face down on a flat and clean surface.
2 Screw one end of the hand strap to the shield-like cover on the back of the terminal.
3 Insert and hook the other end of the hand strap to the bottom of the terminal.
4 Make sure the hand strap is securely attached to the terminal.
5 Adjust the length of the hand strap to suit your handbreadth.