User's Manual

134
9200 Mobile Compute
r
Reference Manual
CCD READER SETTINGS
Barcode Reader Description
CCD Reader Tap the Barcode Reader button to configure reader settings for the
CCD scan engine.
 Refer to the Reader Settings Table in Appendix II - CCD (SM1).
Decode Session Timeout Sets the maximum time (configurable from 1 to 9 sec) for the
decoding process during a scan attempt. The default value is 3 sec.
Redundancy Level Sets how many successful readings should be done before linear
barcodes such as Codabar, MSI, and Interleaved 2 of 5 can be
decoded. Levels 1 to 4 available.
The readings needed for each level are as follows:
Level 1 The following barcodes must be successfully read
twice before being decoded: Codavar, MSI, Industrial
25 (Discrete 25), Interleaved 25.
Level 2 All barcodes must be successfully read twice before
being decoded.
Level 3 All barcodes must be successfully read twice before
being decoded, except for the following which must be
read three times: MSI, Industrial 25 (Discrete 25),
Interleaved 25.
Level 4 All barcodes must be successfully read three times
before being decoded.
Scan Mode Sets the reader’s scanning behavior. Default is “Laser”.
 “Continuous” to decode the same barcode repeatedly or decode
different barcodes in a continuous motion.
 “Laser” for scanning by pressing the scan trigger.
Timeout Between Symbols Only available for Continuous mode. The default value is 1 sec.
1D LASER READER SETTINGS
Barcode Reader Description
Laser Reader Tap the Barcode Reader button to configure reader settings for the
laser scan engine.
 Refer to the Reader Settings Table in Appendix III -ʳLaser (SE955).
Decode Session Timeout Sets the maximum time (configurable from 1 to 9 sec) for the
decoding process during a scan attempt. The default value is 3 sec.