User's Manual

145
Chapter 7 Using Reader Configuration Utility
7.2.8. SYMBOLOGY SETTINGS
On the Symbologies tab, determine whether to enable or disable a specific symbology.
Note: The symbology settings vary by the scan engine (CCD, 1D laser or 2D imager)
installed.
1. Open Reader Configuration as described in Launch Reader Configuration.
2. Tap Symbologies tabbed page.
 Refer to Appendix I - Scan Engine Settings for the symbologies supported by the
installed scan engine.
 Refer to the Symbology Settings Table in Appendix II - CCD (SM1).
 Refer to the Symbology Settings Table in Appendix III - Laser (SE955).
 Refer to the Symbology Settings Table in Appendix IV - 2D Imager (SE4500DL).