User's Manual

6
9600 Mobile Compute
r
Reference Manual
INSTALLING HAND STRAP
The hand strap is ideal for one-handed operation, which requires safe and convenient
hold of the TERMINAL.
Warning: Always make sure the hand strap is well hooked and attached before use.
When the hand strap is desired, install it to the TERMINAL by following these steps:
1) Place the TERMINAL face down on a flat and clean surface.
2) Insert the free end of the strap through the slit and adhere to the strap itself.
3) Hook the other end of the hand strap to the bottom.
4) Make sure the hand strap is securely installed to the TERMINAL.
5) Adjust the length of the hand strap to suit your handbreadth.
INSERTING MEMORY CARD
If you wish to expand memory, follow these steps to insert your memory card (microSD
or microSDHC) to the SD card slot:
1) Press
for the TERMINAL to enter suspend mode.
2) Place the TERMINAL face down on a flat and clean surface.
3) Remove the side plate by unscrewing the two screws (on the right side when you
place the TERMINAL face down) as shown below.
4) Insert the memory card with contacts facing down. Use the stylus to push it into the
slot until you hear a click.
Figure 2: Installing the Hand Strap