User's Manual

22
9600 Mobile Compute
r
Reference Manual
The Character Repeat functionality is enabled by default. Go to Start | Settings |
Control Panel and double-tap the Keyboard icon. You may cancel the check box to
disable it. When enabled, tap, hold, and drag the slider for a desired Repeat Delay and
Repeat Rate.
1.3.2 ALPHA KEY
This alphanumeric keypad is set to numeric mode by default. The Alpha key serves as a
toggle among numeric, alpha (lower-case alphabetic), and ALPHA (upper-case alphabetic)
input modes.
Note: It is not necessary to hold down the [Alpha] key.
The alpha icon will appear on the status bar in a sequence as shown below.
Status Icon
Alpha Key Input Mode
N/A Numbers
Press
one time
Lower-case alphabetic
Press
two times
Upper-case alphabetic
Note: If you are using the software keypad via SIP, tap CAP (Caps Lock) to toggle
between upper case and lower case alphabetic modes.
1.3.3 SPECIAL KEY
Status Icon Shift Key Input Mode
Press one time
T
he Shift key modifies the next key
pressed.
 For 29-key keypad operation, it will
result in different symbols. Refer to
錯誤! 找不到參照來源。
.
1.3.4 FUNCTION KEY
The [FN] (function) key serves as a modifier key, and the functionality of each key
combination is application-dependent.
1) To enable this modifier key, press
on the keypad. Its icon will appear on the
status bar.
2) Now press another key to get the value of key combination (say, press [1] to get the
value of F1). The icon will go off now.
3) To get the value of another key combination modified by the [FN] key, repeat the
above steps.
4) To abort the key modification, press
again, and the icon will go off.