User's Manual
53
Chapter 3 Configuring 9600 TERMINAL
This is the control of networking over USB cable. It is enabled automatically when
the TERMINAL is connected to PC via USB cable.
This is the control of Ethernet module AX88772. It is enabled automatically when
the TERMINAL is seated in the Ethernet Cradle.
When available, the connection status icon will appear on the taskbar.
When connected, this icon will become .
When disconnected, this icon will become again.
This is a shortcut to GPRS connection. Note that the power to the /PRS module
must be turned on through Power Management
for establishing a
connection.
When GPRS power is turned on, the icon will become .
When connected to a GPRS modem, the status icon will appear on the
taskbar.
When disconnected, this icon will disappear.
This is the control of 802.11b/g module for wireless local area networking (WLAN)
connection, which is not available until the power to 802.11b/g module is turned
on through Power Management .
When available, the connection status icon will appear on the taskbar.
When connected, this icon will become .
When disconnected, this icon will become again.
This is the control of Bluetooth module for wireless personal area networking
(WPAN) connection, which is not available until the Bluetooth Manager
is
executed.
When available, the connection status icon will appear on the taskbar.
When connected, this icon will become .
When disconnected, this icon will become again.
Note: By default, DHCP is enabled for networking. Instead of using DHCP, select
[Properties] and specify a static IP address to the TERMINAL. Only change these
settings according to your network administrator's instructions.
Toolbar Items Description Remarks
Tap this button to open the Connection menu. The
available options depend on the connection you
select.
T
ap and hold the icon of a
desired connection type.
T
hen, select an option from