User's Manual

11
Chapter 1 Use Mobile Compute
r
1) Loosen the handstrap and pull it downwards so the metal hook is positioned at the lower
edge of the Velcro band
2) Unhook the hand strap by pressing the square metal ring lightly in the middle and lifting
it upwards in a single motion.
Note: The lower end of the handstrap can be left as is without detaching. After the main
battery is installed, the handstrap can be hooked back into place.
3) On the outer sides of the battery door are two door latches. Pull them outwards to
unlock battery door.
4) Lift up the lower end of the battery door to remove it.
5) Position the main battery pack into the battery chamber with the contact pins facing
down. Fix the bottom edge first.
6) Press the upper end of the main battery inwards until the clip at the top “clicks” into
place.
7) Replace the battery door. Fix the upper edge first and then press the lower edge in. Push
the door latches back to their original position.
8) Secure the handstrap hook back into its groove.
Note:
(˄) When main battery level drops to low level, charge it ASAP or replace it with a
charged one.
(˅) Always turn off the mobile computer to replace the main battery pack.
(3) The battery door must be secured in place for the mobile computer to operate.
(4) Any improper handling may reduce battery life.