User's Manual

FEDERAL COMMUNICATIONS COMMISSION
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:(1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
Limited Module Approval Statement:
This device is intended only for OEM Integrators. The OEM integrator should
be aware of the following important issues.
Labeling of the End Product
The end product integrate this module has to be clearly identified on the label
that this end product contains a FCC approved RF module. The format of
such statement could “Contain
Tx FCC ID: Q3N-ID-20” or similar.
Integration Note
The transmitter module may not be co-located with any other transmitter or
antenna.
The OEM integrator is responsible for testing their
end-product for any additional compliance requirements required with this
module installed (for example, digital device emission, PC peripheral
requirements, etc.)
In the event that these conditions can not be met, then the FCC authorization
is no longer considered valid and the FCC ID can not be used on the final
product (including the transmitter) and obtaining a separate FCC authorization.