User's Manual

81
Chapter 4
4.3.1 BARCODE READER SETTINGS
The barcode reader configurations depend on the scan engine(s) installed. You can
tell which reader is currently in use and make necessary changes on the General
tab.
BARCODE READER DESCRIPTION
CCD/Laser
Reader
If enabled, tap the [Barcode Reader] button to configure the
reader settings for CCD or Laser scan engine.
 Refer to the Reader Settings Table in Appendix II – CCD/Laser
Scan Engine.
2D Reader The 2D scan engine is capable of reading linear and 2D
barcodes.
If enabled, tap the [Barcode Reader] button to configure the
reader settings for 2D scan engine.
 Refer to the Reader Settings Table in Appendix III – 2D Scan
Engine.
4.3.2 RFID READER SETTINGS
If the RFID scan engine is present, configurable options will be displayed.
Note: Because it is possible to read barcode and RFID tag at the same time, it is
recommended that only one scan engine is enabled at a time to prevent
from misreading.
Some RFID tags support both read/write operations, on a page-by-page basis. You
may find it necessary to define your own read/write operation. For reference only,
the table below lists the start page for read/write operation on a number of RFID
tags.
START PAGE TAG TYPE
-1 Start from byte 0 of the default page (see below) for all tags
3 Mifare Ultralight (ISO 14443A)
4 SR176 (ISO 14443B)
3 ICODE SLI (ISO 15693)
0 LRI512 (ISO 15693)
3 SRF55VxxP (ISO 15693)
0 EM4135 (ISO 15693)