User's Manual

Terminal Reference Manual

1.5.3 VIBRATOR

The mobile computer is integrated with a vibrator, which is software programmable

for feedback. This can be helpful when working in noisy environments.

1.6 DATA CAPTURE

1.6.1 BARCODE & RFID READER

A wide variety of scan engines is available for delivering flexibility to meet different

requirements. Depending on the scan engine integrated (check the "Active Device"

setting in ReaderConfig), the mobile computer is capable of scanning barcodes of a

number of symbologies that are enabled by default. If you need to scan barcodes

that are encoded in a different symbology, use the Reader Configuration Utility to

enable the symbology first.

Refer to Appendixes for details on scan engine settings.

 Appendix I – Scan Engine Settings lists the symbologies and RFID tags supported.

 Appendix II – CCD/Laser Scan Engine provides information on the reader settings

as well as symbology settings for the CCD or Laser scan engine.

 Appendix III – 2D Scan Engine provides information on the reader settings as well

as symbology settings for the 2D scan engine.

Note: The mobile computer allows the co-existence of one integrated scan engine

and the RFID reader.

1.6.2 DIGITAL CAMERA

An integrated 2 mega-pixel CMOS camera inside the computer is specifically

designed for collecting image data. Refer to the Image Capture Utility.

1.7 COMMUNICATIONS

1.7.1 USING THE CRADLE

The cradle is designed for charging and communications at the same time.

1) Place the cradle on a flat and clean surface.

2) Connect the line of the power adaptor to the power jack on the back of the

cradle.

3) Connect the power adaptor to a suitable power outlet.