User's Manual

Operations MediaVault 4440 User Manual
5-12
MV 4440_Ciprico Inc.
Mode Change Procedure
To change the mode, perform the following.
1. Turn off the computer.
2. Select a mode.
3. Set the mode number at the MODE SELECT switch, located at the rear of
the MV 4440. See Figure 5-3. Use a pointed object (such as a pen tip)
to press the desired button at the M
ODE SELECT switch.
• Press the upper button to increase the mode number.
• Press the lower button to decrease the mode number.
FIGURE 5-3. Mode Select Buttons.
4. Turn off power to the MV 4440.
5. Press and hold the MODE SET button (see a description of the button on
page
5-1
4)
6. Apply power to the MV 4440.
7. Keeping holding down the MODE SET button until two beeps are heard
to confirm the mode change.
8. Release the MODE SET button.
Press
to change
to change
Press